Hey folks,
we are planning to upgrade our Nexus 5500 devices from 5.2(1)N1(2a) (via the intermediate release 7.0(4)N1(1) ) to 7.1(5)N1(1).
This is a classic VPC design, so the upgrade should be straightforward.
However, we are unsure about wh...
@xthuijs Suppose we have:
1x 100 Gig uplink
1x 10 Gig downlink
On the downlink we have an *outgoing* ACL dropping more than linerate (lets say 30 Gbit/s of traffic from a DoS). Does this cause any issues with the rest of the downlink traffic on the...
@xthuijs That's great, but in my use-case I'm neither using MPLS nor am I load-balancing. What I need is to match the layer 4 port encapsulated in pppoe in vlan in vlan. If this can't be done on the 9k, then I need to do it on the BNG (which is a box...
By default the ASR1000 appears to handle this in the SPA, which has limited scalability especially when it comes to specific second-dot1q matches.
Use the following command to handle this in the QFP instead:
hw-module subslot slot/subslot ethernet ...
Should be tomahawk cards.
According to the datasheet, those cards are supported since 6.2.1 without distinction between 32 and 64 bit.
According to the release notes, the cards are supported starting from XR 6.2.1 and XR 64-bit 6.2.1.
Seems pretty ...
