How can i upgrade the uccx 7.0(1)bulld 109 to Version 7(0)2,when i start 7.0.1SR01_build210 ,which is the first avaialble download, it stop and prompt the error, this build is meant for 7.0.1SR01_build168. this are the available upgra...
I have a situation in one of my cluster , the publiser server is down with error on console" "NO INT 13h devices found" .I did reboot the server serveral times by removing drives, placing if firmly, running the support cd to upgrade the bios" but ...
"High Traffic try again later" on phone display in cucm ver 6.1.1. and users are getting busy tone., no dial tone for 5 to 10 minutes, the cpu usage is not more than 25%, i have huge phones and GW as well. single cluster with no WAN IPT branch. so...
when a call comes into callmanger how the end device is selected in comparison to translation point, route point,cti route point,how ccm determine the order?whether the its hits TP ,CTI ,RP ?
i have a situation, i want to enable the ip rtp compression betweeh hq and remote site's routers. here is the scenrio..a. HQ router ethernet interface is connected to satellite modem, and the remote site router is also connected thru ethernet to sate...
hi Jonathan !i dont have the Build 168 ,,,which is the pre-requisite to use the 7.0.1-SR05_Build504 .Mr current version is uccx 7.0(1)bulld 109 ,,,iam looking for build 168.cisco download website is not showing any listing of this servi...
I stop those error from vg224 and vg248, but still the problem exists, after debug in voice gateway i found the Vocie gateway is sending cause value of 41 to PSTN which in turn sending NETWORK BUSY instead of NUMBER BUSY. at the same time the phone d...
May i rephrase the question once again, what is the selection order if the call is presented to CCM which it hits first is it TP ,CTIRP,RP and any other entity.
yeah,i know ,cannot enable it,, but iam looking for any alternate way,, without adding a serial interface,,,is it possible to do it thru qos settings, or can we make it thru gre tunnel interfaces.