Hello -
I have some 2960x stacks that are dropping their 10g connections back to their main closets. This is a straight fiber connection to and from the main switch in the building and the edge switch drops it's connection to the main switch for abou...
Hi all, Don't have too much experience setting up a 2511 term server. When I try to connect to a device from my terminal server, I am getting prompted for username/password. The banner for my term server also comes up. When I put in my username/passw...
Hello,I have two SSIDs on an Autonomous Access Point, that goes to a 2960 switch, that connects to a L3 3560. I have a vlan for admin/private internal access that uses the native vlan (1) and guest vlan (50). I have configured both and I am trying to...
Can someone explain to me the exact purpose of, when creating an instance of BGP on a router, when to and not to implement the address-family command? And, if so, what is the purpose?
Hi all -I have a 5510 that acts as a firewall for my location. My internet router lies outside of this and I am trying to TACACS to it, however I get an Asymmetric NAT rules matched for forward and reverse flows error when trying. I am seeing hits on...
Thanks for all your help. I ordered two new octal cables and it worked. Both cables I had were bad. Thanks again!!Sent from Cisco Technical Support iPhone App
I basically re-did it, and put only the basics on. Current configuration:!version 11.3service timestamps debug uptimeservice timestamps log uptimeno service password-encryptionservice udp-small-serversservice tcp-small-servers!hostname Router!enable...
It's funny that I get the same response to a connected device that is turned on and turned off. It's like I am bouncing the telnet session back to the 2511.
Cabling has been checked and rechecked. The connected devices I can get to by consoling in normally. I redid the config on the terminal server and only put the basic stuff on, and still get the same.
