About Julian Regel

Julian Regel · 05-23-2017

Hi I have a Cisco ASA 5510 in single mode that is used for IPsec VPN site-to-site tunnels. I would like to migrate the VPN tunnels onto a 5525X running in multiple context mode (i.e., create a new context and move the configuration onto it). Does ...

Julian Regel · 04-26-2017

Are there any recommendations regarding the use of the "admin" context in an ASA multi-context configurations? Can it be used for normal firewalling duties, or is it recommended to not use it for general use? Thanks!

Julian Regel · 05-20-2016

I have an ASA that is being used for AnyConnect VPN access. The ASA has three interfaces: inside, outside and management.The management interface is for:- administration through ASDM from a host on the management network- syslog to a centralised log ...

Julian Regel · 06-19-2015

I'm looking at deploying a pair of ASA 5515-X firewalls and would like to use contexts to create virtual firewalls for different purposes. I'd also like to add some resilience by configuring the pair either in active/standby or active/active (not sur...

Julian Regel · 06-17-2015

If I have an ASA with 5 security contexts enabled, how is syslog handled? Is it on a per-context basis, or centrally from the admin context?I'm evaluating a logging solution that is licensed per "device", where each device is a unique syslog source. ...

Julian Regel · 05-27-2016

Thanks for the clarification. I hadn't seen that update.

Julian Regel · 05-27-2016

Thanks for the reply. I've had a look at both links, but I can't see which bits are required to solve my issue. Please can you advise? Thanks.

Julian Regel · 05-27-2016

Thanks for the reply. I don't think you can run AnyConnect VPN in a context, so splitting isn't an option? I was hoping there was a way to separate routing for management plane traffic from data plane traffic, but it looks like this may not be possib...

Julian Regel · 06-23-2015

Thanks for the comment Vibhor. Does what you say only apply to Active/Active configurations? What would happen in an Active/Standby with 5 contexts on one ASA and 2 contexts on the secondary? Also, when you say "admin + 2 contexts", I was under the i...

Julian Regel · 06-20-2015

Thanks! I've looked at that link and the following text seems relevant:You have two ASA 5540s, one with 20 contexts and the other with 10 contexts; the combined license allows 30 contexts. For Active/Active failover, one unit can use 18 contexts and ...

Member Since	‎05-31-2010 03:43 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	22

User Statistics

User Activity

Migrating ASA configuration to a context

Multi-context ASA use of admin context

Access to management network

ASA context licensing in active/standby or active/active

ASA Contexts and Syslog

Thanks for the clarification.

Thanks for the reply.

Thanks for the reply.

Thanks for the comment Vibhor

Thanks! I've looked at that