outsideA B \ / R |insideR=2801 Router, A and B are the WAN links.While having a dual WAN interface is normally not an issue, both of the links use DHCP, so when you attempt to place a track stament on the route, it's not an option if you incl...
Both the 3750 series and many of the blade switches have stack connections however I have been unable to find anything that addresses the compatability of their stacks. Ideally I would like to stack 3750s and Blade switches, but so far I have not see...
I have a 5505 that refuses to change VTP mode to anything other than transparent. It acts as though it has taken the change, but when you show vtp domain, it shows it as back in transparent mode. The VTP server is a 2924, and there is another 5505 in...
That link is dead, this is a newer link. They are a bit light on details, not specifying what will be used for "non-standard" or allowing you to configure a specific IPG time. They do note that it only works on 10g interfaces.https://www.cisco.com/c/...
I believe that what you are looking to do is only on higher end switches such as the Nexus line. It also can create less than optimal switching situations. If you don't have a very good reason for doing that I would recommend against implementing it.