outsideA B \ / R |insideR=2801 Router, A and B are the WAN links.While having a dual WAN interface is normally not an issue, both of the links use DHCP, so when you attempt to place a track stament on the route, it's not an option if you incl...
Both the 3750 series and many of the blade switches have stack connections however I have been unable to find anything that addresses the compatability of their stacks. Ideally I would like to stack 3750s and Blade switches, but so far I have not see...
I have a 5505 that refuses to change VTP mode to anything other than transparent. It acts as though it has taken the change, but when you show vtp domain, it shows it as back in transparent mode. The VTP server is a 2924, and there is another 5505 in...
I believe that what you are looking to do is only on higher end switches such as the Nexus line. It also can create less than optimal switching situations. If you don't have a very good reason for doing that I would recommend against implementing it.
Etherchannels work on a 1 to 1 basis. If you want switches A and B to talk to switch C, each will need to have a seperate port channel built on C. stacked switches count as a single logical switch.This assumes A and B have links to C! Switch Aint po ...