machiavelli
Level 1
Level 1
Member since ‎06-07-2005
‎08-18-2017

User Statistics

  • 13 Posts
  • 1 Solutions
  • 22 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
1 Accepted Solution
5 Replies

User Activity

Hi.Is it possible to create port channel (L3 interface bundling) between two L3 switches which ARE NOT directly connected? Both switches are connected with four interfaces to the L2 device, and those L2 devices are connected to two routers which are ...
Is it possible to create port channel (L3 interface bundle) between two L3 switches (sw1 and sw2) which ARE NOT directly connected? sw1 - l2sw1 - l3sw1 - l3sw2 - l2sw2 - sw2
Hi. Two of my company's routers, are connected with 2 serial connection with each other. No multi link interfaces are defined. Serial 0 works fine, but Serial 1, after issuing "no shut" command, works couple of seconds, and change it's state to "Seri...
As I can see on it's backplane, I'm sure that Cisco 831 router has four 10/100 BASE-T RJ-45 interfaces (integrated switch) + one 10BASE-T RJ-45 interface (WAN ethernet port), but "show run" output shows two extra interfaces. "show ip int" output disp...
Hi,I have problem to enable CEF on my Cisco 831 router (2Eth+4FastEth ports). As I can conclude, default IOS on it (12.3(2)XE3) supports CEF, but I have problem with enabling. When I type "IP CEF" in config mode, router stop responding for a few seco...
Community Statistics
Member Since ‎06-07-2005 11:49 PM
Date Last Visited ‎08-18-2017 03:55 AM
Posts 13