Greetings,I am wondering on this switch cisco WS-C4510R+E (MPC8572) can the cards on the right side of the chassis bus area be changed out?  Or are they programmed to be bound to the slot/chassis they come from?  See how the one on the top is burnt b...

Is there a way to tell other than visually that the backplane has been upgraded to fix the design flaw it has when a card takes a power hit and burns out.  I am assuming that these metal rings were put on the new chassis to handle this issue.  Notice...

Greetings,can this command be issued "no hardware ejector enable"  then press the ejector buttons and move the levers on a line card that is in a minor alarm and then use "hardware ejector enable" after we are done, without issue?  I posted this ques...

I have  a card in Minor alarm on a Cisco 7000 and wanted to know if issuing no hardware ejector enable command will allow me to reset the buttons and levers without an issue.