These units do not have much available RAm to handle high volume info with VPN. Have you tried using OpenVPN, since it has become the normal method of using VPN.
You may want to look at stepping up into the newer line that Cisco has.
These units a...
No problem. That is odd that it took a few resets. I had the same issues as the TP-Link that I have for standby. I have had my 320 for so long that I finally had to swap out the CMOS battery. Two of the screws are under the feet.
I would do a IP/MAC bind still and file a ticket with Ubiquiti. I was looking at them when I was looking at replacing my old Engenius 2.4ghz A/P and decided to go with the EAP1750H. The fact that Engenius also updated the firmware to allow for hand...
This is a Dual WAN unit, there is no trunk port on it. If you have not downloaded the Router Administration manual, I would suggest doing so. As for configuring VLAN, it really depends on what you intend to do with segmenting different groups into ...
You can manually assign any device that allows it, to have a Static IP and then go into the unit and plug in the MAC ID and Static IP, without having to have the unit to do a discovery.Something that you are doing is not working for those Access Poin...