About Chris Gahlsdorf

Chris Gahlsdorf · 08-20-2013

We are setting up a VPN tunnel with a vendor and I want to only allow Pings, and one specific port. I thought you could do that through the crypto map on the ASA 5510 but it looks like it has to allow all IP traffic and then you filter out using a VP...

Chris Gahlsdorf · 01-05-2011

Don't worry this isn't another load balancing question. I know that is not possible.But I have 2 ISPS and I would like to use 1 for my VPN tunnels and 1 for my internet.Right now I just have my last default gateway as going ISP1Interface 0.0.0.0 ...

Chris Gahlsdorf · 02-09-2021

Whats really annoying is Prime is supposed to be a single pane of glass, not a single pain of glass. I just want it to pull SNMP data from the Nexus, show me utilization etc. I dont need it to configure, but I want to see the data. With Prime I can ...

Chris Gahlsdorf · 02-08-2021

Well I am new and using a trial of Prime 3.9 and I can tell you its still not supported. This may be a deal breaker

Chris Gahlsdorf · 08-22-2013

Thanks Jouni. That was very helpful and I accomplished what I wanted to!

Chris Gahlsdorf · 08-21-2013

Thanks Jouni this is really helpful! But I thought to use the vpn-filter you had to change the global sys setting? Is that incorrect?

Chris Gahlsdorf · 02-11-2011

SO I think I may have it working now.... it looks like I needed to add some NATing in order for the Comcast modem to send the traffic back correctly. Does what I did make sense? I ONLY want NATing on the Comcast interface (Vlan 1001)Current configura...

Member Since	‎01-05-2011 10:01 AM
Date Last Visited	‎02-10-2021 12:15 AM
Posts	13
Total Helpful Votes Received	15

User Statistics

User Activity

Best way to filter VPN Traffic

ASA 5510 dual ISPs

Re: Nexus 93180YC-EX vs Prime Infrastructure 3.1.4 - Device Pack 7

Re: Nexus 93180YC-EX vs Prime Infrastructure 3.1.4 - Device Pack 7

Best way to filter VPN Traffic

Best way to filter VPN Traffic

Re: ASA 5510 dual ISPs