About Tom Looyer

Tom Looyer · 03-08-2015

Hi,I have been playing around with the "memory free low-watermark" command. However, the amount of free memory reported by this feature is not consistent with the output from the "show processes memory" command. See below. switch#show proc memProcess...

Tom Looyer · 08-17-2013

Hi All,I am having trouble with EIGRP default network advertisement.I have entered the ip default-network 172.16.0.0 command on R1.The route is marked as a cadidate default on R2 but gateway of last resort is not set. Why?Also, the static route on R1...

Tom Looyer · 11-18-2012

Hi All,I have just purchased a second hand Cisco 2821. There is a password set and password recovery functionality is disabled.A bit of searching around shows that you can reset the router to factory default configuration by pressing break at the cor...

Tom Looyer · 03-15-2015

Hi Madhukrishnan, This occurs instantly after entering the command "memory free low-watermark processor 10000". Thanks, Tom

Tom Looyer · 11-09-2013

Anyone have an answer to this?

Tom Looyer · 08-19-2013

Hi Reza,Below is the complete route tables from R1 and R2.Note the static route to 0.0.0.0/0 appeared when I entered the ip default-network command.R1#show ip routeCodes: L - local, C - connected, S - static, R - RIP, M - mobile, B - BGP D - EI...

Tom Looyer · 08-18-2013

Hi Reza,Thanks for you reply, however I think you have misunderstood my question. I am more concerned about the behavior on R2.R2 has marked 172.16.0.0/16 as a candidate default but it has NOT set it as the gateway of last resort. Why not?The documen...

Tom Looyer · 11-18-2012

Hi Leolaohoo,Thanks for your quick reply.I took out the CF, started the router up, issued a break key.Re-inserted CF (so the router has an IOS to load from when it resets). I typed "confreg 2142" followed by "reset" and the router reloaded with the d...

Member Since	‎11-18-2012 06:40 PM
Date Last Visited	‎12-02-2019 12:25 AM
Posts	8

User Statistics

User Activity

"memory free low-watermark" different to "show proc mem"

EIGRP default network advertisement

2821 PASSWORD RECOVERY DISABLED

Hi Madhukrishnan, This occurs

CME incoming Call should display name instead number

EIGRP default network advertisement

EIGRP default network advertisement

2821 PASSWORD RECOVERY DISABLED