Hi,I have the same error (https://bst.cloudapps.cisco.com/bugsearch/bug/CSCva83873/?rfs=iqvred) on WS-C2960X-24PS-L. I upgrade to latest ISO.(15.2(4)E8) power off the sw an up but the same error. POST: PortASIC Port Loopback Tests : Begin
POST: Fail...
Hi, I have very old Cisco router (878) . It ATM port is Up and working. I want to route site B to A.so I set 1.1.1.1 on site A router and set 1.1.1.2 on site B router ATM interface. on site B router I can see remote network. can ping any host on remo...
Hi,
I have a very high utilization on one of my 2960 port! this port is connected to my hp server. I got this server when my server is not booting with os.
show interface gi1/0/15
GigabitEthernet1/0/15 is up, line protocol is up (connected) Hardwa...
Hi,TNX for reply.It was in old config. ATM interface and vlan1(LAN side) interface has the same bridge group,I do not have any BVI now.should I remove bridge group?!
I have a Linux cluster with 2node!
my servers have the same hw/sw configuration. all connected to the same switch.
All of my server were working for 2 years without any problem but since 2-3 month ago one of them have a problem. flooding phase frame ...
As you said I connect pc to bad port . it was OK.
I remove portfast settings from my port and connect my server again. after 4days it seems that the problem has been solved!
TNX
