I am new to this and starting into configuring our ISE servers with policies for allowing endpoints to authenticate using 802.1X. I am taking a phased approach to this so I don't accidently shut down the whole network. After much research, I started ...
I am attempting to use EEM to build an applet that will automatically backup the configuration to a TFTP server after changes are made per DISA STIGS. I have tried different variations and still come up with no backup.First I tested the command #cop...
I have been trying to configure 2FA for the ASDM UI for our ASA 5512-X. There has been no success and it seems that there is no software solution. Yes, there is 2FA for Any Connect and for VPN, but not for an administrator using ASDM. This is somethi...
Which type of attack can be mitigated by authenticating a routing protocol? I know that we use authentication for OSPF, BGP, etc. to prevent attacks, but what attacks does authentication prevent?
Thank you,
I am perplexed by my issue. I have one switch out of 9 that cannot authenticate with our TACACS server. The configurations are the same as every other switch, yet when I try to log in using the TACACS+ account, access is denied. Here is the configura...
I tried to make it work, but as soon as I implemented the Monitor ACL on the switch, I couldn't ping its IP and of course couldn't print.I just have to wait until it shows up again. Of course, this particular printer is one that is not on the pre-bui...
I finally found the Endpoing.LogicalProfile. I created a rule for the printer and hope it works. I will give a shot a today.Thank you for your assistance.
@Mohammed al Baqari Thanks for reminding me. There are a lot of prebuilt profiling policies, but one of our printers is not listed, so I ended up building one for that specific printer. I will also remember to do the authentication to continue.
@Marcelo Morais Thank you for your response. I attempted to follow you instructions, but I am having difficulty with step 3. 3. Authorization Policy Rule Name: Printer-MAB Condition: Endpoint.LogicalProfile EQUALS Printer-ProfilerI went to Authoriz...
Can command:Copy run tftp:10.0.0.10/switchname.cfgReturnsAddress or name of remote host [10.0.0.10]? I hit enter key to acceptDestination or filename [switchname.cfg]? I hit enter key to accept!!16715 bytes copied in 10.160 secsI checked the logs and...
