Hi,
I've also seen this behaviour in 10.2(4) and current recommended 10.2(6),
Duplicated in the lab, setup 4 SPF+ 10G interfaces in de same quad (e1/9-12) with qsfp>sfp+ convertor. Logging from connected test switch:
Remove of convertor+10G SFP in Et...
Hi there,
At a customer site we are experiencing problems with Bosch AUTODOME IP starlight 5000i IR IP camera's. If the camera is connected to a C9300L switch everything works fine. When we connect it to a C9410 with C9400-LC-48P line cards we end up...
Hi there, We are hitting this bug. The "Known Fixed Releases" releases are really old. Suggested release is now Release 15.2.4-EA9. But cannot find in the release notes if this bug is fixed in it or not. Anybody an advise?The software and hardware we...
Hi all,For a custom embedded tab we want to add call variables in a URL.From cisco documentation:The following is an example of how you can use the ${UserID} token:1 You specify the following in your custom embedded tab:<url>www.cisco.com/${UserID}/p...
Would you apply port 2-event as switch global on all access switches? I've never seen it active in a network config at other customers. (i'm aware of the impact on power budget impact of port 2-event)
So I've got the same problem. After succesfully pnp and onboarding of switches I had to delete them from the inventory (due to tshoot CSCwe10508), and discover them again. They end up in unclaimed under PnP and completly OK in inventory.
As above me...
I also seem to have the same problem with C9410 dual SUP with upgrade by DNA-C to 17.3.5 > 17.6.4
Redundant System Information :------------------------------Available system uptime = 2 hours, 21 minutesSwitchovers system experienced = 0Standby failu...
