Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day gentlemnI have a 350 with a minimal config on it. I am trying to ping from my 3 VLAN to my 252 VLAN on this switch and it will not allow it. I am sure I am doing something wrong, But I cannot figure it our or even if I can do so.Here is the ...
Everytime I boot I have to do a "copy startup-config running-config" to get my config up. I know this is a no-brainer, But I have no brain left. EVEN IF I "COPY RUNNING-CONFIG STARTUP-CONFIG" OR "WR MEM". I still boot up in a "router>" prompt and my ...
I got a brand new 3845, It has the IPBASE-mz-124-17a IOS, they sent me a disk of IOS's. Should I replace the flash with ADVIPSERVICESk9-mz-124-16b, or is that a jump too far? Also what would be the best way to do this?
I have a new Point to Point Cleas DS3 circuit which will terminate at both ends in a 3845, what would be the appropriate modules for such a circuit in a 3845
Good Day gentlemenI currently work at a small Subsidiary of a larger company and my Boss wants to know how we can put a VPN solution in place in order to outsource some developemnt processes allowing the new partner to access through our firewall the...
I have now, Also, I did not have anything connected to VLAN 252, once I did I could ping it. I haven't installed it properly yet to see if I can route traffic to it. As soon as I do I will probably be back..Thanks Jon
Hey RickThanks for the info, I don't know too much about this. I am trying to configure it as a straight T3 connection point to point. SO If you have a link to the configuration commands for this particular module (NM-1T3/E3) I would be very grateful...
Hey RickThanks for the info, I don't know too much about this. I am trying to configure it as a straight T3 connection point to point. SO If you have a link to the configuration commands for this particular module (NM-1T3/E3) I would be very grateful...