Greetings,i need configure an e1 card on UC520-24U-8FXO-K9, but the info founded to make it is not complete, i don't sure what is wrongThe e1 is up but i can't send or recive calls,and i don't know how associate the trunk pstn trunks.that is the info...
Hi, i have Cisco Secure Server and my switch ahenticate with it in telnet way, but when i login in Cisco Network Asistance this not works.this is my conf for AAA access:username ***** privilege 15 password *****aaa new-modelaaa authentication login ...
Hi, i have two 2620 in h323 gatekeeper mode coneceted to PBX with E1, sometimes it make a congestion tone.how i can do make a debug or troubleshoot to find the congestion?thanks..
Hi,i have 2 Catalyst 3750 with Layer 3 ios image.how i can do to configure a VTP Domain and Configure InterVlan Routing in both switch for same LAN, each switch it connected to differents routers in differents sites, but both is the same LAN.thanks.....
Hi,i have implement QoS in my network for VoIP, i must configure WFQ in my lan ports? (switches and routers lan interfaces)and my e1 interfaces to PBX too (Router - VoIP Gateway)?thanks.
its because are the the default configuration make it by the CCA interface, i think will be needed showed,i can't configrue digital DP until associate the trunk-group to voice-ports i think..do you know another doc or sample to trunk-group, voice-por...
I include the "network-clock-select 1 e1 0/2/0" and avoid the splits, thanks, and i hope compare to your VZ movistar site configuration, thanks again.I don´t configure the e1 associates dial-peers yet, nor the trounk group all_t1e1, i don't know how...
UC520#sh controllers e1E1 0/2/0 is up. Applique type is Channelized E1 - balanced No alarms detected. alarm-trigger is not set Version info Firmware: 20090408, FPGA: 13, spm_count = 0 Framing is NO-CRC4, Line Code is HDB3, Clock Source is Line. ...
