About j_finley

j_finley · 12-10-2004

I have a weird issue and need advice. I hard set all my switch ports to 100/Full. I have all my IP phones directly connected to the switches. My PC's are plugged into the phone. I hard set the PC's to 100/half. When running some applications that ...

j_finley · 12-10-2004

I have a weird issue and need advice. I hard set all my switch ports to 100/Full. I have all my IP phones directly connected to the switches. My PC's are plugged into the phone. I hard set the PC's to 100/half. When running some applications that ...

j_finley · 11-23-2004

I have PC's connected to VoIP phones where it is in connected to the switch. I believe I have all the ports configured correctly however, my VoIP phones on VLAN20 for instance cannot retrieve an IP from our DHCP server. The DHCP server is configure...

j_finley · 11-15-2004

I currently have two Cisco PIX 515’s in failover mode connected to my core switch (C4003). Also on that switch, I have a print server that I need to traffic shape because some customers are getting their link saturated. The customers are printing t...

j_finley · 11-16-2001

----------I have two ISP's. They are not the same carrier or medium. T1 and Cablemodem. I have a 2621 router where I'm running NAT say 172.16.100.254 for the router IP. I have setup policy routing for my NAT pool, when I purposly pull my T1 which...

j_finley · 02-28-2005

Thanks for the responses. What I did was set the ports to auto/auto. I can't hardset the phones and after doing that all is well. I just hate using auto because of known past problems with certain NICS & NIC Drivers.

j_finley · 12-10-2004

Well, in the past, I've ran into HUGE problems leaving ports set to auto because they would be constantly checking/challenging which speed/duplex to be at. I was always told to hard set both sides.

j_finley · 12-03-2004

Hubbell makes really nice 4u lockable wall mount cabinet.

j_finley · 11-30-2004

Do I need the router FastE's to be plugged into the same switch? or can they be on separate switches? I have the IP helper command on the voice vlan port of the router.Also, do I need to create VLAN interfaces for each VLAN and assign them an IP? I...

j_finley · 11-30-2004

Ok, I have every port set to AUX Vlan, even ports with a server plugged into it. I don't notice any problems though?! All my configs till now are coming from a book "Cisco Catalyst LAN Switching" from McGraw Hill. It seems a bit dated as I've been...

Member Since	‎11-16-2001 06:20 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	18

User Statistics

User Activity

PC <-> Phone <-> switch duplex problems

PC <-> Phone <-> switch duplex problems

VoIP Phones/VLAN-DHCP

re-Design question

Two ISP's running w/ NAT failover not working

Re: PC <-> Phone <-> switch duplex problems

Re: PC <-> Phone <-> switch duplex problems

Re: Wallmounting Catalyst Switches

Re: VoIP Phones/VLAN-DHCP

Re: VoIP Phones/VLAN-DHCP