I have 2 Firepower module (ASA 5525) with Malware and IPS licence. Recently i changed the Malware policy action set to "Block Malware" and "Reset Connection". How to log the event if my policy blocked any files? Please find the attached screen shot f...
How can I put the source port (src-port) as any in the below ASA command instead of specific port?
packet-tracer input ifc_name protocol src-ip src-port dst-ip dst-port
packet-tracer input outside tcp 192.168.10.10 3389 172.16.10.10 3389
cisco...
I am trying to configure CCP (cisco configuration professional). It is discovering the device. But while going to configure, getting the error as "Your Internet Explorer does not have Java enabled. To run Cisco CP, you must enable Java. For instruct...
Based on the attached topology I configured area 2 as Totally NSSA. So area 2 will receive default route from R3 and R6 (ABRs).
R9 (EIGRP) is advertising a default route to R7. So why that default route is not showing as LSA type 7 in R7?
Thanks,
Ma...
Hi All,
Based on the attached output there is Feasible successor in router R3. As far as I know, since there is a feasible successor the EIGRP router doesn't send a Query to it's neighbors. But here it is sending. Any idea?
Thanks,
Manu
I use ADVENTERPRISEK9-M), Version 15.2(2.3)T. FYI.. i tested it in the virtual lab using EVE software. I observed the router rebooting when using 'ipbasek9' image.
I also faced the same issue. After I changed to advance enterprise image the issue got resolved.Moreover I noticed that when you apply the command - crypto ipsec transform-set TSET esp-3des esp-md5-hmac, the router won't take ESP authentication part....
Do you have a WAN link monitoring tool? If so, open multiple ping session with high data rate. Make the link fully utilized and check the utilization in the tool.
BR,
Manu Shankar