About Jeroen1001

Jeroen1001 · 02-28-2018

Dear expert,I'm talking about the section under Work Centers > Device Administration > Device Admin Policy Sets. In our setup, the device is present under 2 distinct Network Device Groups. One time using a supernet /24 (management subnet) and one ti...

Jeroen1001 · 02-12-2018

Dear community,I'm looking for ISE to remove sensitive information from the output of certain commands. For example, when issuing a show run command, I want to remove (or replace with *) all lines containing the word username and all lines containing...

Jeroen1001 · 11-10-2013

Hi everyone,I'm looking to pick these up for a company with a growing network. I'm, however, confused about the SFP(+) ports. Ok, so there are 4 of them that can work at 10 gigabit speed simultaneously.What is the purpose of the 2 additional 5 gigabi...

Jeroen1001 · 02-26-2011

Hello everybody,I've got a SLM 2008 smart switch. I've set the following options to switch port 1 which has the role of being a trunk port.1) Enable Tx force untag: disabled2) Ingress filter: disabled3) Acceptable frame type: tagged only4) PVID: 1All...

Jeroen1001 · 02-23-2011

Could you please help me with following question. I've done my best to convey everything clearly, but if there are any doubts, please ask me to clarify.The manual says:When this option is enabled, all egress frames from this port become untagged. The...

Jeroen1001 · 03-07-2018

It appears not to do this. It always goes to the same policy linked to the most specific IP. I can't find what's wrong so I decided to open a ticket with support!

Jeroen1001 · 02-23-2018

Hi GeorgeI did find a way, I think. I'm going to test this next Wednesday. One can define an alias on the CPE and exclude items.for instance: alias Test show run | exclude password|user|etcThen you put config in ISE allowing a user to call only that ...

Jeroen1001 · 02-13-2018

Dear Krishnan,Many thanks for your reply but I meant in it another context. Say I give access to a CPE to a third party. I want this 3rd party to be able to do a show run, but without seeing any sensitive information. Basically, I want to ISE to tran...

Jeroen1001 · 02-27-2011

Oh no:), now I need to trunk my VLANs to the router.But we don't do networking on Sundays:))

Jeroen1001 · 02-27-2011

I took 25 minutes to type that haha. It is often hard to convery things about VLANs clearly.The main issue I had is that descriptions seldomly state the flow/direction of traffic. For the Tx force untagging I didn't now whether they meantA)device ---...

Member Since	‎02-17-2011 05:52 AM
Date Last Visited	‎03-09-2018 01:47 AM
Posts	15
Total Helpful Votes Received	1

User Statistics

User Activity

ISE selecting wrong Device Admin Policy

Can ISE parse the result of an authorized command?

SG500X-48 SFP(+) ports

Native/management vlan not working?

VLAN: Enable Tx Force untag (SLM-2008 smart switch)

Re: ISE selecting wrong Device Admin Policy

Re: Can ISE parse the result of an authorized command?

Re: Can ISE parse the result of an authorized command?

Re: Native/management vlan not working?

Re: Native/management vlan not working?