Hi guys,I want to have some discussions about the etherchannel with lacp enabled.From LACP protocol, an aggregation group binds the ports with the same speed, duplex and linkstate. Therefore, for ports with speed 100 and speed 1000 will belong to the...

Hi all,Can the port profile in nexus1kv be assigned to the specified uplink? For example, if I have two uplinks and one vm connect to the nexus1kv, and I want the traffic from this vm only go through one of the two uplinks, how can I configure that? ...

Hi guys,I have a question about mac ACL. It says that "MAC ACLs—The device applies MAC ACLs only to non-IP traffic.". So, what does non-IP traffic mean? Does mac acl can deny tcp traffic? I began netperf at first and then set the acl(deny such tcp so...

Hi all,I got a problem when I install nexus1kv on my esx host. The vsm is successfully connected to the vc, and the status is:acl-nexus(config)# show svs connectionsconnection vc:    ip address: 10.117.8.38    remote port: 80    protocol: vmware-vim ...

Hi all,I know that we can run script with run-script command in nexus1kv. But how can I write the repeated command in the script? Does nexus1kv support the loop in the script, such as for or while? I can't find the material about it. Thanks in advanc...