Kaleem Sheikh
Level 1
Level 1
Member since ‎09-26-2016
‎05-03-2019

User Statistics

  • 15 Posts
  • 0 Solutions
  • 5 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
First Discussion
5 Discussion Posts
10 Discussion Posts
1 Reply
5 Replies

User Activity

I am trying to change my split tunnel (with internet access) into a full tunnel with internet hairpin so I can VPN into a remote ASA and go out to the internet through that ASA.  The ASA I am using is a 5506-x. I have entered the tunnelall and same-...
I'm setting up a site to site VPN and I have allowed split tunnel on a Cisco ASA 5506-x. When I connect through the Anyconnect on my PC, the internet connection works, but I am connecting from a PC on a xx.xxx.xxx.235 network VPN'ing into a xx.xxx.xx...
I'm setting up a site to site vpn and I hate allowed split tunnel. I can connect and the internet connection works, but I am connecting from a xx.xxx.xxx.235 ip addr VPN'ing into a xx.xxx.xxx.234 and my ip after VPN'ing is still xx.xxx.xxx.235. I nee...
configured nexus 7000 module f1 to connect to my router, but i keep getting a 'no route to host' error. does this have something to do with the l3 and l2 features on the nexus? I initially allowed for my nexus to be l3 during the setup, if that's the...
I have all my 7960 phones connected to a 2960 switch and none of my phones are working, I think it is a router problem. My router is a 2911 and the config is below: ART-RTR#show runBuilding configuration... Current configuration : 6887 bytes!! Last ...
Community Statistics
Member Since ‎09-26-2016 01:43 PM
Date Last Visited ‎05-03-2019 01:42 AM
Posts 15
Helpful Votes Given To