About keith.holder

keith.holder · 04-28-2016

I've searched the web and the forums but can't find the answer to my question. Hopefully someone can fill me in. If I don't configure QoS on a 2960x or 3850, what is the default behavior in regards to dscp/cos markings arriving to the switch from a...

keith.holder · 02-25-2015

Hello everyone. I have an issue where I'm unsure why one route is selected over another and can use your help. Here's the scenario. I have a 3750X stack that runs EIGRP with my WAN provider's router and my ASA. All neighbors are on the 10.41.1.0/24...

keith.holder · 12-10-2012

Hello all. I recently upgraded my 5520 to 9.0.1 IOS. Today I tried to apply a capture to my inside interface referencing a simple ACL and I get this error.ERROR: Capture doesn't support access-list <capin> containing mixed policiesI also created a ...

keith.holder · 11-29-2012

Hello all. I have an issue with some clients that seem to have poor ping times but I can't give the users a reason why. Pinging from all tested wireless clients to their respective LAN gateway router almost always results in 3ms to 10ms response tim...

keith.holder · 05-03-2012

Hi,I recently installed NCS and have received a major alert stating the following: "NCS disk volume 'optvol' is above the recommended disk usage, more than '50'% used"The VM was created from the NCS OVA file and I only have one 2500 controller in NCS...

keith.holder · 04-28-2016

Thanks for the quick answer Mark! I appreciate it.

keith.holder · 02-25-2015

Thanks Jon. Sometimes, you just need someone to remind you how you configured things. :). Here's what happened. I'm running IP SLA on ASA to automatically redistribute static routes for L2L IPsec. What I did, though was set the AD on the routes t...

keith.holder · 02-25-2015

Thanks Jon. I couldn't get the output to filter just 10.0.0.0/8 so I provided the entire output.Here's the output from the ASA.MACTASAFW01# sho eigrp topology all-linksEIGRP-IPv4 Topology Table for AS(99)/ID(65.41.39.48)Codes: P - Passive, A - Active...

keith.holder · 12-14-2012

In addition to Scott's answers, your switch ports that connect to LAPs should be set as access portsSent from Cisco Technical Support iPhone App

keith.holder · 12-11-2012

I found out late last night from TAC that the error I posted is because the ANY keyword is referencing ipv4 and ipv6. The ACL syntax should read ANY4 to specify ipv4 only in my case. I'll test this later today. Thanks Andrew. You are correct but your...

Member Since	‎03-01-2006 06:17 AM
Date Last Visited	‎09-19-2018 08:42 AM
Posts	23
Total Helpful Votes Received	30

User Statistics

User Activity

Default Trust Behavior - 2960x, 3850

EIGRP route selection

Capture with ASA 9.0.1

One client slow, one client fast

NCS - Disk volume 'optvol' more than 50% used.

Thanks for the quick answer

Thanks Jon. Sometimes, you

Thanks Jon. I couldn't get

Re: best practices on wlan configuration

Re: Capture with ASA 9.0.1