Hi folks, I'm managing several ASR9010 routers, and have issue with only 1 of those ASR9010 routers.Let's call the issue router "A", and the router is running IOS XR 6.2.3I'm tyring to apply a new created PBR for some bundl-ethernet interface on A bu...
Hi, I'm setup an asr9010, but cannot ssh to it and cannot use "crypto key gen rsa" command. Please kindly help to take a look. Every time I tried to login, the log shows "SSHD_[65713]: %SECURITY-SSHD-3-ERR_GENERAL : Failed No Host Key configured on ...
Hi,
I have an asr9010 running IOS-XR 6.2.3 and configured 2 VRFs on it.
I got an error when configuring static route from default and VRF-01 to sub-interface belongs to VRF-02.
Below is the configuration, and the last few rows are the error messag...
Hi,
I was always using QoS to limit the bandwidth of interface.
And got an issue on my Catalyst 2960G switch. Once I've applied the QoS, the host connecting to the port(I've found the issue on G0/9) will be disconnected. However, this QoS works go...
Hi Georg, Thank you for giving me a helping hand, and here are the outputs of several routers.# ASR9010 that doesn't work at all RP/0/RSP1/CPU0:R1#sho ver
Fri May 8 23:11:39.686 PDT
Cisco IOS XR Software, Version 6.2.3[Default]
Copyright (c) 2017 b...
Hi buddy, I disabled the flowspec and apply the PBR, and the error message became .Also, I have also checked the following guide and still didn't figure out what does the "internal error" mean.https://www.cisco.com/c/en/us/td/docs/routers/asr9000/sof...
Thanks buddy, since the issue router is running in a production network and the flowspec is in use, I have to schedule the maintenance carefully. I will update here if I got that chance.
