Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings,
I've been reading about VxLAN BGP EVPN, and wondering if it's possible to deploy DCI without using VRFs. I just want to extend L2 between two datacenters, and looking for an alternative to flood and learn.
Thanks in advance.
Hi everybody,I have the following behavior applying service-policy on SVIs with two differences: ###########################################################################Case 1: 2801 - IOS c2801-advipservicesk9-mz.124-18.bin - It works fine!!!polic...
Hi,I'm trying to install a default IPv6 route through RA ND on a serial link. This is my configuration:R4#ipv6 unicast-routing!!interface Serial0/1 description Connected to R5 ipv6 address 2001:4444::/64 eui-64 ipv6 nd prefix 2001:4444::/64 infinite ...
Hi Thatikonda,Yes. I forgot to say I'm using HWIC-4ESW for the SVI.Additionally Cisco documentation says it works with version 15.1 or later. The point is, I can't understand why it works on version 12.4-18. Regards.
In fact, this should be the behavior for the serial link:06:08:25: ICMPv6-ND: Selected new default router FE80::AEA0:16FF:FEAC:C6C2 on FastEthernet0/2006:08:25: ICMPv6-ND: Installed default to FE80::AEA0:16FF:FEAC:C6C2 on FastEthernet0/20Thanks,Oscar...
