Hello everyone.I'd need some assistance in using the Service Control Engine (SCE) API.I have developed a simple application that queries the bucket data for a given subscriber (using the getQuotaStatus API). However, despite I believe the source code...
I have a cisco 2811 IOS C2800NM-ADVSECURITYK9-M),12.4(24)T with 4 WIC-1ADSL connected to 4 ADSL lines; two of them works correctly the other two lines no, they remains on initializing state. Is this configuration possible or not ?Thanks to all
Thanks so much again for your help.Sadly, this is a production SCE (with tens of thousands subscribers) so I can't do anything of these. I also have another two SCE1000 and SCE2000 but they are in production too, and their subscribers don't have asso...
I have already opened a TAC last week, but it's progressing very slowly and it seems quite hard to debug.Thanks so much for spending time to help me.ps: the ip 123.123.123.123 is a placeholder. There is no NAT nor firewall between the SCE and the API...
Thanks again for helping me.I've followed the guide you linked (both the 3.6.5 and 3.7.0) line by line. I've also upgraded the OS and the API jars to 3.7.0, but the result is the same.The only difference with my configuration is in this screen:the gu...
Many thanks for your answer.I've added the lineRDR-formatter destination 127.0.0.1 port 33001 category number 4 priority 100 in the configuration. There are no other destinations for category 4.By the way, I see that this problem is still open on 3.7...