About ronald.go

ronald.go · 10-03-2016

I have a brand new C1941 to replace old C1840. The strange thing is that ge0/0 works perfectly but ge0/1 doesn't want to go online when connected to any switch; it does wake up when I connect my laptop's gigabit ethernet directly to it. I've tried ...

ronald.go · 10-04-2016

difference between 890, 1840 and 1941: 890 is a gigabit router with built-in 8-port gigabit switch. 1840 is a fastethernet router (2x FE) and the 1941 is a gigabit router (2x GE). the cable tester reports that the cables i was using were ok. when y...

ronald.go · 10-03-2016

hi Leo i've set and reset the speed/duplex setting to all available settings and also on the mux as well as on various switches. just no joy... i've tried both straight-through and cross cables as well... the strange thing is that the older 1840 r...

ronald.go · 10-03-2016

hi Enrico the mux is actually at my side and so I have been able to change the config to full duplex and fixed speed. the problem is that even on other switches (except the dlink dgs, which is unmanaged), the port just doesn't go online... but on la...

ronald.go · 10-03-2016

hi Pawan I'm using all copper cabling as the WAN fibre broadband has a mux provided by the ISP that talks gigabit ethernet (RJ45).

ronald.go · 10-03-2016

hi sh run int Gi0/1 gives Building configuration... Current configuration : 128 bytes ! interface GigabitEthernet0/1 ip address 10.0.0.69 255.255.255.0 duplex full speed 1000 no cdp enable no mop enable end sh int Gi0/1 gives GigabitEthernet0/...

Member Since	‎10-03-2016 12:40 AM
Date Last Visited	‎02-12-2021 02:39 AM
Posts	7

User Statistics

User Activity

Cisco 1941 ge0/1 won't connect via switch but works when laptop connects

difference between 890, 1840

hi Leo

hi Enrico

hi Pawan

hi