About remitprosupport

remitprosupport · 09-20-2011

Hello all. I've got an ASA 5510 that has been working like a charm for some time now. Until now we've not had to nat any resources to the outside. I created network objects for an internal host and an external host. The internal host has to respond t...

remitprosupport · 08-12-2011

Hello all...I have a pair of C3750X's which are configured in a switch-stack (which is working as expected), but I'm having trouble getting them to join the same power stack. I have the power stacking cables connected in the following fashion: Switch...

remitprosupport · 07-29-2011

Hello all. I have an ASA 5505 that has had a working configuration with several AnyConnect clients using dual authentication for weeks now. My normal process for adding new users has been to configure the user in both authentication databases and the...

remitprosupport · 03-25-2011

Hello all,I have a catalyst 2960 (12.2(53)SE2) that I've added several mac ACL's to. This was almost 2 days ago, but this morning one host connected to a port where an access-group was assigned lost connectivity with the rest of the network. Connecti...

remitprosupport · 03-18-2011

Hello all!I've got an ASA 5505 (ASA 8.2(3), ASDM 6.3(4)53 for which logging seems very slow.In the ASDM real-time log viewer, log entries come in spurts of 20, pause for a few seconds, then I get 20 more. The net result is that entries don't show unt...

remitprosupport · 09-21-2011

Julio,Thanks again for your reply. Because this was time-sensitive, I opened a TAC with Cisco and they were able to resolve the issue. As you pointed out, the access rule on the outside interface needed to allow access to the outside interface its...

remitprosupport · 09-20-2011

Thanks for the reply Julio. I tried changing the destination IP address in the ACL from my inside host to that of the external IP address of the firewall in the ACL and I still get the same denial message. Do you have any other suggestions?Thanks!

remitprosupport · 07-29-2011

Just answered my own question. I decided to look at the Advanced/SSL Settings page and noticed the SSL version for the security applicance as a "Server" was set to TLSv1 only. I know I configured it that way at the time, but why working AnyConnect cl...

remitprosupport · 03-30-2011

Bruno,A few days ago when I added your suggestions to my config, I added the ethertypes allowing ARP and IP to the mac for the printer, which was f4ce.4637.4337. This worked fine for the past couple days. This morning though, our JIRA server lost con...

remitprosupport · 03-28-2011

Thanks for the suggestions. I've implemented your first suggestion (setting the ethertypes). I've also re-instated the access-list on the other node without setting the ether-types. Both are working for now, so I'm going to give them a couple days to...

Member Since	‎02-04-2010 01:18 PM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	45

User Statistics

User Activity

Static NAT for outside access not working...

Switch in Switch-Stack Will Not Join PowerStack

Some AnyConnect Clients Cannot Connect to ASA 5505

Delayed loss of connectivity after adding mac access-list

Slow Logging on ASA5505

Static NAT for outside access not working...

Static NAT for outside access not working...

Some AnyConnect Clients Cannot Connect to ASA 5505

Re: Delayed loss of connectivity after adding mac access-list

Re: Delayed loss of connectivity after adding mac access-list