About Brandon Browning

Brandon Browning · 12-06-2022

I am trying to write a CPL script to change the source URI for outgoing video calls originating from Call Manager. We are running Expressway 14.0.8. I also looked at some older posts, and those examples didn't seem to work either, and I am not for ...

Brandon Browning · 01-07-2016

I am trying to change the source URI for calls originating from our internal network going out to the internet. We have an internal domain that is not routable on the internet and would like to change it to the routable domain. Example: Internal ...

Brandon Browning · 01-07-2016

Thanks! That worked great! We did have the inbound working, but did not use a CPL script. We made the change for the inbound URI on the search rule on the expressway C that pointed to CUCM.

Brandon Browning · 09-16-2015

As Jaime said, this is correct behavior. It looks at all the numbers/patterns in the partitions that are in the CSS applied to the phone/dn when determining a best match. Since both of these numbers are accessible from the CSS, the interdigit timeo...

Brandon Browning · 09-16-2015

If you have an access code (Such as 9) for outbound calls it shouldn't be an issue assuming you are not stripping this off before sending the call to the gateway. If the call is being sent to the gateway without an access code, it could send the cal...

Brandon Browning · 09-16-2015

Do you have an inbound voip dial-peer configured on your router? It not, it will be matching dial-peer 0 when CUCM sends a call to it and could be causing you issues. Your inbound voip dial-peer could look something like this: dial-peer voice 1 voi...

Member Since	‎10-20-2011 04:14 PM
Date Last Visited	‎12-07-2022 12:03 AM
Posts	10

User Statistics

User Activity

Expressway CPL Script to Change Source URI

Expressway E v8.5.1 // Change Source URI for Outgoing Call

Thanks! That worked great!

As Jaime said, this is

If you have an access code

Do you have an inbound voip