About g-campbell

g-campbell · 02-02-2016

Hello. I have inherited a CSM Application installed on a VM device. I know that it is version 4.8 but I am trying to verify if it is the standard 4.8 release or if it is the 4.8 with SP1 release. The original installation file has been deleted a...

g-campbell · 12-17-2015

Hello, As we all know sometimes Cisco documentation can be a little ambiguous and or vague in defining technical feature principals and this applies no less to the definition given to the ASA same security level feature. I have been searching and sea...

g-campbell · 09-16-2015

Hello,I am looking for definitive confirmation that the Nexus 5500 series do not support WCCPv2.Does anyone know if it is not supported on 5500 series switches regardless of NX-OS version or if certain minimum NX-OS versions will support it? Regards ...

g-campbell · 12-12-2014

Hello,This is my first time working with the X genertaion of firewalls. I note from an output of show interface ip brief I get an additional 4 interfaces along with the gigabitethernet interfaces, namely: Internal-Control0/0 127.0.1.1 Y...

g-campbell · 02-18-2014

Hello,We are running a simple VC traffic marking setup across multiple IOS routers of mixed hardware 2921, 2801, 3925 and 3945s.Our aim was to simply mark packets from a particular VC source at each site and set the dscp to af31, for the ISP routers ...

g-campbell · 02-04-2016

Hi Dinesh, Ths does not answer my question. My question was about how to visiually verify the CSM version installed. I need to determine if CSM 4.8 with SP1 is installed. Thanks & Regards

g-campbell · 01-31-2014

Daniel,Thank you for the feedback. Primary motivation is the fact our ISP seems to have intermittent link or route flaps on their BGP IP4 VPN MPLS service on the primary circuit. We have no visibility over this. This is only reflected in an OSPF...

g-campbell · 05-31-2011

Ok, thanks that was my general understanding too, just hoped there would be no need for any fancy class-maps etc. Thanks very much

g-campbell · 08-26-2009

VLAN 4095 is usually used by Blade Centre AMS management modules to manage blades using VLAN 4095 Serial Over LAN

g-campbell · 12-18-2007

It certainly is, as long as you follow the basic configuration requirements for all etherchannels in IOS. We run multiple Gigabit Etherchannels between 3750 stacks (8 units and individual 3560 switches. Later revisions of IOS allows a 3750 to suppo...

Member Since	‎11-30-2005 12:38 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	32
Total Helpful Votes Received	10

User Statistics

User Activity

CSM - Verifiying the Application Version

ASA Same security Levels - Inter-interface - Definitive understanding required

Nexus 5596UP Support for WCCP

Cisco ASA 5525-X Internal Interfaces

Cisco Class-Maps and set dscp show 0 packets marked

Hi Dinesh,

OSPF Dual homed WAN Links - Preventing failback

Re: Using a Cisco ACE as a router

Re: vlan 4095

Re: Ether Channel and stack