Does anyone have the command to retrieve PPM information from VxWorks for example I can do showModule <module #> to get the information about a card (specifically the Serial Number) looking to get the same information about the PPM. Also the command...
I'm trying to turn up a OSC port on the TNC card and will not come into service. When you try to create an OSC termination you get the following error:
1 OSC termination was not created, as follows: slot 8 (TNC), port 1-1 (OC3), EID-3239 The over...
I have a 2 node turn up that had 2 SMR2c cards connected to together and brought up a ochnc on it now I've changed the one node and put a SMR1c and Amp-17c card - increased the distance to 60Km and can not get the Line-TX to start to shoot so I'm ass...
I have configured a 100G-LC-C card paired with a 10X10G-LC card in MXP mode. The one node is in-service but the other side has an OTUK-LOF alarm/LOM condition as well. I've changed fibre patch cords from the odd shelf to the card but my levels seem...
We have 2 nodes that are in a terminal configuration. The fibre between the 2 nodes is 20 Km, the node has a SMR2, OSCM and GE-XPE card in the chassis. We have manually configured the node and on the SMR card we have the OSC and Line ports in green...
Hi Faisal,
Thanks for the reply - the internal patch cords were completed already the problem was when I set this up I only had one TNC card and originally there was TSC cards in the box so I upgraded the one TSC to a TNC but I believe (didn't have...
Thank you Sunil. That worked. My question is I took the values from a production node that had the same length as the lab spool but obviously those didn't work. How can I get those values beside using CPT if I have a similar span in production?
