Hello,I have a scenario where an analog device (sccp controlled and connected to a cisco analog voice gateway) performs a call to an IP phone and when the IP phone terminates the call, the line remains active in the analog device.Note that all calls ...
Hello all, We are going to upgrade our IPT infrastructure to 12.5 version and convert all our traditional licenses to smart.My question is about CSSM Satellite. Apart from preventing CUCM to talk directly with the Internet, does it have any other fun...
Hello all, a dumb question, but just to be safe.I log in to UCCX (2 nodes cluster - version 11) and get the message that the JTAPI client versions are inconsistent.I realize that I have to do the resync on both UCCX nodes and then restart the CCX eng...
Hello,I want to implement a project with 3 L3 switches. The equipment must support full L3 capabilities (especially OSPF) and multicast (PIM, IGMP). Due to budget restrictions, I cannot go with C9300, so I was thinking about C9200L with the Network A...
Hello,I am a little confused about the perpetual vs the dna license.I want to buy a C9200L-24T-4G-A switch that will be used for a new implementation concerning multicast streams.The features that I need include routing, multicast routing, VLANs, etc...
The operation center phones are 7821/8851 IP Phones, registered in the same Call Manager.The lift phones are phones mounted behind the button panel of the elevators
Yes, they have the exactly same configuration. So, it must be a device issue, not a VG issue.So, as an alternative solution, I was thinking if I could set a "timer" on the VG port connected to the lift phone to drop any active call after 45 seconds, ...
PLAR config is done on CUCM.I will try your config, as well as removing/modifying the cptone configuration on the VG and inform the thread accordingly.Thank you very much for your help!
