Hello Community    I have successfully been able to connect to my network  configuring the ASA to allow Cisco Anyconnect client.   Once connected, i am not able to browse the internet but i am able to ssh/http onto my servers.  I suspect i have not c...

Hi, Ok, so i have completed wiped the config of the ASA 5506, I still cannot get access to the ASDM via the inside interface. When i enable the BVI 1 interface, manually assign an IP address and set gig 1/2 as bridge group 1 this works . Is there a...

ASA 5505 interface Ethernet0/0 ( THIS IS MY OUTSIDE INTERFACE) switchport access vlan 2 interface Vlan2 nameif outside security-level 0 ip address 209.X.X.X 255.255.255.248 interface Vlan1 nameif inside security-level 100 ip address 192.168.15.1 255....

System Name      Cisco Master AP  Model                   AIR-AP1832I-E-K9Software Version  8.3.112.0Management IP Address 192.168.108.99 Guys,I am trying to set this Primary AP up, below is my scenario:  Local users currently have a LAN address of 1...

Hi All, Would you be able to shed some light on the below error message?  If you could look at the screenshot attached, it will show you the current setup. I have set this up using the ASDM, the packet is being denied when going from:  Outside R1 to...