tdrais
Rising star
Rising star
Member since ‎05-23-2006
‎08-18-2017

User Statistics

  • 660 Posts
  • 60 Solutions
  • 34 Helpful votes Given
  • 549 Helpful votes Received
Recent Badges
100 Helpful Vote
50 Accepted Solution
15 Accepted Solution
1 Accepted Solution
5 Accepted Solution
 30 Helpful Vote
300 Helpful Vote
10 Helpful Vote
1 Helpful Vote
50 Replies

User Activity

I am running a number of sites with 4 circuits between them using load balance by packet.They work well as far as balance goes but I have had issue with file transfer throughput being very low. During testing I can actually get better throughput by ...
We have a need to secure the ports on a switch. This is in a mostly uncontrolled location but the switch itself is secure.First we thought to use simple mac locking but a consumer router can bypass that out of the box. We also looked into a layer 3...
Is there something special about these cards and pinging against a hard loop.We have all the channels mapped and have the serial interface up/up looped. We do the normal ping my own ip to test the cable. It consitantly gets loses. We move the loop...
Anyone know what this command does or where it is docuemnted.Accidently typed it in. It is a non enabled command that appears to display some type of debugging information. If I had to guess it is ospf events but I cannot find anything to confirm t...
Community Statistics
Member Since ‎05-23-2006 05:58 AM
Date Last Visited ‎08-18-2017 03:55 AM
Posts 660
Total Helpful Votes Received 549
Helpful Votes From
Helpful Votes Given To