I have two ASR1002 with the same exact configuration. One is able to issue ICMP traffic just fine while the other cannot even ping its own assigned IP addresses. The only difference here is that one has an ESP installed while the other does not. Does...
I am getting a blank window with a flashing cursor after establishing a telnet or ssh session to the ASA. I am tempted to reboot the device but want to know if anyone has sees before and what was their fix?Regards,
Does anyone what is the latency on the 6509 from the time a packet enter a switch to when it is delivered assuming all layer 2? Attached are the modules:i am currently reading http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps708/product_d...
I take this back. It is working. I am not sure why I coudln't get it to work in the past or if I changed anything in the config between then. in any case, it is working.
Hello Pete,
I actually tried your suggestion to no avail. I am still looking for a fix. I am using ASA version 8.4(7)26 and Cisco AnyConnect anyconnect-win-3.1.10010-k9.pkg
132 -rwx 2137 23:52:56 Sep 23 2014 RA-SSL-Profile.xml
group-p...
I don't have vrf Mgmt-intf enabled on either ASR.
ASR with ESP installed
Interface IP-Address OK? Method Status ProtocolGigabitEthernet0/0/0 10.2.253.9 YES NVRAM up upGigabitEthernet0/0/1 10.1.95.249 YES NVRAM up upGigabitEthernet0/0/2 unassigned YE...
Thanks for the quick reply. I thought of that but I should at least be able to ping its own IP address. The management interface will only be used for that purpose and i cannot use it for other purpose such as routing to other transit network.