v4.xx receivers now support syslog. This document demonstrates how to use a free logging tool to capture diagnostic logs for D9854, D9858, D9824, and D9859 receivers.
Demonstration of how to configure a D9858 for simultaneous HD & SD output (via ASI) of the same HD program. Accomplished via DPM and Transcoding menus.
Rob;
Here is the document which I wrote quite awhile ago. The procedure to perform this with a D9859 should be the same, as the D9859 has 8 transcoded outputs, while the D9858 only has 2.
Fred
Robert;
To change channels for each program entry (PE), you may simply use the <UP> and <DOWN> cursor keys. The current PE will be shown in the top left hand corner of the front panel. Typically, it will be set to PE1. To make changes for PE's 2 t...
There are no user serviceable parts in the receiver. If chips were removed from the unit, there is no other option but repair of the unit. Please contact Cisco DMN Support for details.
If either '1234' or '8390' will not work, then we can conclude that it must be a unit pre-programmed with a custom password. Certain programmers (eg. A&E, Hallmark, Scripps, etc.) have units with custom passwords. In these cases, the only option is...
