Have another issue where certain FXOs just lock up. The LEDs on the UC shows an active call but there isn't one. Port sum shows weird statues - I'm trying to find my debug logs. I have to shut / unshut the FXO so that calls can go through. I have o...
Customer has an issue where 10 digits dialing to a certain number doesn't work. The number does not require a 1 or 0. When you dial the area code + the number the called digits stop at the first seven. I've included a snippet of my dialing peers. ...
When the customer parks a call inbound or outbound, they cannot make an outbound call from any phone. Has anyone seen this before? FYI, they are running the latest IOS, CUE, and phones loads.
I've configured 3 phone numbers, one on line 3 and 2 on line 4 (spa400s) to ring a hunt group. When you dial the number it just rings and rings but the system never picks the call up. I used the admin manual to configure and verified my syntax. An...
I had a similar issue today. I could load ASDM and see all the tabs but none of the FirePOWER tabs would load when I clicked on them. I could access them from another management PC just fine. I had been using this PC for years to manage multiple A...
Not sure how typical this is Marcos I've had two different TAC cases open and it still isn't resolved. There is something else going on. Or if not, how do I know when to use supervisory disconnect signal or battery-reversal? And how come TAC hasn’...
