Hi,We are using 3825 and 3945. For one our PRIs, we want to limit the no. of simultaneous calls to 10 (instead of 30). Searched through the docs but couldnt find any parameter or dial-peer config to do that. Is this achievable?RegardsAnupam
When I try to configure a voice port (like voice-port 0/0/0:15) after doing a conf t, it gives me an error of invalid input detected. What could be wrong?We are using a Cisco 3945. Please let me know if you need any show run/show ver outputs. We have...
Are there any gateway sizing options document for Router 3925E?We are trying to figure out the scalability numbers for 3925E if we use it as a router and a vxml browser.The sizing table below only talks upto 3800 series.http://www.cisco.com/en/US/doc...
Hi - We have a Cisco Router 3825 which we use to convert phone calls from PSTN to SIP.Can any one suggest us (or point to a documentation) as to how can we use this router as a load balancer (to balance load among different SIP terminals) ?ThanksAnup...
Thanks Chris! That was very helpful!Looks like I was searching only the 3925E docs and not the CVP docs for all this while.btw, the performance numbers are way up for 3925E than 3825!CheersAnupam
