Hello,I'm going to upgrade our ASA5525-X to the new 9.1(1) software which should support new ASA CX.Has anyone tried new version of software with Context-Aware? Do I need to buy licence to enable CX?Thanks and have a good day!
Hello,I have interesting and strange issue at the moment. I have two 4500 L3 switches with 2 GB port-channel between them.I can't see any errors, latency between them. When i ping our office which is on MPLS from switch1 I am getting 100 % success ra...
Hi,We ordered 4x cisco 2960 switch with LAN Lite software by mistake. Can we upgrade them to Lan Base?When I change boot image I get Error: hardware not supported by firmware.
I need an advice with my vpn design.I have two cisco ASA 5505 devices and two cisco switches plugged to ASAs in each office. I need to create a VPN tunnel between two offices.Network behind the ASA1 in office1 is 192.168.1.0/24 with DHCP server – 19...
I noticed that NAT Based on Destination IP doesn't work when you have logging enabled.For example:access-lists 101 permit ip host 10.90.4.1 host 192.168.230.66 logaccess-list 102 permit ip host 10.90.4.1 host 192.168.250.66 logIs there any explanatio...
It is a bug of the IOS. Check this bug CSCti75491 details.Symptom:C3750x and C3560x switches may fail the POST port loopback test on some ports when booting with the error %PLATFORM_ENV-3-LOOPBACK_PORT_POST_ERR: Gi1/0/X can't be brought up because it...
I think you are right. I'm going to check with our supplier if we can get a hard drive for the ASA so we can install the software. Otherwise I'll raise a ticket with Cisco TAC. Thanks.
dir disk0: shows that I have the image:135 -rwx 69318656 09:41:10 Dec 06 2012 asacx-5500x-boot-9.1.1-1.imgI tried to delete it and reupload it again, but I'm still getting the same error.Storage device not found. Install drive and try again...
