Hi, I'm struggling with my configuration, seems I can not get it work. First I will explain my situation, next my config and my problem. Situation; My situation is explained in situation.jpg The routers which I manage are the two third party routers and the cisco 1841 router. My configuration; My configuration is uploaded in configuration.txt This is the 'orgininal working configuration' WITHOUT a problem. My problem; As you can see, I have an active/passive BGP configuration. I wish to get two active/passive configurations so that I can route half of my traffic trough ISP1 (backup on ISP2) and half of my traffic through ISP2 (backup on ISP1). I will not use maximum path options (load balancing) The traffic that is designated for ISP1 is located in 10.0.0.10 through 10.0.0.20 (third party router NAT on) Traffic that is designated for ISP2 is located in the announced subnets (third party router NAT off) I designed route-maps, to route traffic, but it seems that it will only work for incoming traffic. I will not post the results I already get, because I think it will presume some configuration options (I need a fresh sight on my problem). Sources used http://www.cisco.com/en/US/tech/tk365/technologies_configuration_example09186a00800945bf.shtml http://www.cisco.com/en/US/docs/ios/11_3/np1/configuration/guide/1cbgp.html Thanks in advance!
... View more