About johannes.nielandt

johannes.nielandt · 11-11-2016

Hi community, I'm having a Catalyst 6800 VSS with multiple L3 uplinks to routers.Each of these links are dedicated L3 without MEC. Is it recommended to use BFD on these interfaces or not? Especially what happens if my active Sup fails, does it bring...

johannes.nielandt · 01-22-2014

Hello community,I'm planning a upgrade procedure for a Nexus 7000 vPC enviroment with M1 I/O modules to M2 I/O's.I have already contacted TAC and Cisco engineering about this upgrade. Unfortunately I have received different answers about a possible m...

johannes.nielandt · 06-05-2018

Me too, even with managment-access inside After software upgrade the login was not possible anymore. I removed the management-access from config and reconfigured it. That fixed it.

johannes.nielandt · 11-11-2016

Hi, thank you. My problem is a indirect connection via some provider hardware.No link-state is propagated to the partner router. I think I have found an answer in the meantime: SSO—BFD 12.2(33)SRE 12.2(33)SXI2 12.2(33)XNE 15.0(1)S 15.1(1)SG Netw...

johannes.nielandt · 01-22-2014

Amit Singh schrieb:option 1:Do you mean to replace the I/O on both sides at the same time?Answer : No, Just do it one-one. Shut down the PL on Primary VPC peer. Secondary will put all the interfaces to down state. Then change the I/O on secondary to...

johannes.nielandt · 01-22-2014

I have received the answer that it is supported to mix M1/M2 I/O modules for PL and PO on both peers. But with is only supported with NX-OS 6.2(2).So having M2 modules on the left hand side and M1 on rigth hand.Amit Singh schrieb:What is the Answer/c...

Member Since	‎06-24-2009 02:16 AM
Date Last Visited	‎09-15-2020 09:09 AM
Posts	6

User Statistics

User Activity

Cisco Catalyst 6500 VSS / BFD OSPF

Nexus 7000 M1 -> M2 vPC upgrade

Re: Yes... I had the same problem

Hi,

Nexus 7000 M1 -> M2 vPC upgrade

Nexus 7000 M1 -> M2 vPC upgrade