Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
To all:Please help.I have a connections(router to router) over frame relay and I configured OSPF protocols. But when I try the command "show ip ospf neighbor", there is no output or no connections found. Is that possible that using frame relay connec...
Hi to all?This is not related to cisco but IP and network related. I only ask, is multiple ip's possible to point in one domain name? How it works? What is the advantages and disadvantages of it?For examlpe:mosnet.com (20.20.20.1 and 30.30.30.1)Hope ...
Is someone who can help me? What is the meaning of the result "%Network not in table"?Router>show int serial1Serial1 is up, line protocol is down Hardware is MK5025 Description: ****Example**** Internet address is 192.168.1.1/30 MTU 1500 bytes, B...
Hi Rick,Your suggestion was invalid because when I try to change the map the output is just like this:Router0(config-if)#frame-relay map ip 192.176.1.18 101 broadcast cisco %Address already in mapRouter0(config-if)#same output at Router5.But when I p...
Now I understand. Thanks for the answer. :)May I know what are the other factor of going down of the line protocol (Line protocol is down)? Can you give me an other scenarios or examples?Thanks in advance..Martee Sacramento
