My situation is simple. I have two branch offices that need access to my servers at HQ. I have all four serial interfaces up/up at HQ and at both branches, but cannot get any traffic routed across the T1's. I need as much help as possible. After ...
After Calling my Telco, they had switching the lines somehow such that the circuits were crossed and the one that was supposed to go to Vonore was actually going to Tellico! How lovely that felt.I can now ping from the remote sites routers to the ro...
After switching to the /30 masks, I still have the same problem.on tellico's 1841 (192.168.1.11 / 10.0.1.2) I cannot ping 10.0.1.2.The same goes with Vonore's 10.0.0.2 as well as HQ's 10.0.0.1 and 10.0.1.1On each of the interfaces though, if I use an...
I am also planning on using the 1841's in place of the netgear's currently running the VPN, but again, only once the T1's are up and functional.--Jeremy
Right now we are using a VPN to access the servers from the branch offices on netgear 318fvs'. I plan on taking this VPN down once the T1's are up. I will leave the boxes at each location if a T1 goes down, but don't plan to have it active. As for...
-------------------------sh ip int b for the second 1841-------------------------Interface IP-Address OK? Method Status ProtocolFastEthernet0/0 192.168.1.11 YES NVRAM up upFastEth...