About ajaylandge

ajaylandge · 06-23-2009

Can one MAC address be learned on multiple ports in same switch? if so, which port will be used to forward frames for that particular MAC address

ajaylandge · 05-28-2009

I have a site to site tunnel between Cisco 2821 router with Version 12.4(13r)T and Netscreen firewall, the tunnel is up and all things seem to be working but it flaps all the time.I get following error continuously: %CRYPTO-6-IKMP_MODE_FAILURE: Proce...

ajaylandge · 06-23-2009

Thanks for the quick response Collin, I was just curious about this, and it is certainly very helpful for me.Thanks againAjay

ajaylandge · 05-29-2009

1.I am assuming that you already have Phase 1 policy defined on both side, if not please configure it.2.Your ACLs should exactly be opposite to each other which are not. 3.Try removing crypto map on Site2 and re add it as it is showing "Incomplete!"4...

ajaylandge · 05-29-2009

Sorry I didn't see the subject line, it's ASA, but doesn't matter, you can add following command in global configuration mode:crypto isakmp nat-traversalThanksAjay

ajaylandge · 05-29-2009

You probably have VPN concentrator as a VPN server, please enable NAT Traversal (NAT-T) or IPsec over User Datagram Protocol (UDP) on it.Please refer TAC case # K71102938 for details.ThanksAjay

ajaylandge · 05-28-2009

here is the updated one

Member Since	‎03-14-2007 01:56 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	7

User Statistics

User Activity

One MAC address on multiple port in Switch

%CRYPTO-6-IKMP_MODE_FAILURE:

Re: One MAC address on multiple port in Switch

Re: Error display in VPN site to site

Re: ASA VPN error

Re: ASA VPN error

Re: %CRYPTO-6-IKMP_MODE_FAILURE: