About gabor.kovacs

gabor.kovacs · 03-14-2007

Hi there,just a short question with this error message.there is an issue with a 2651XM router, when the first bri(what is on the WIC slot) goes down and try to change the clocking to the next BRI module what is on a NM-HD-2V slot.The issue happens no...

gabor.kovacs · 03-20-2007

Fred,With my colleagues we've found a resolution for this issue: "network-clock-priority " under BRI int config mode.By default all int has high priority but if you set all with low except of one what keeps in high, it'll be the master clock interfac...

gabor.kovacs · 03-19-2007

Fred,Thanks for the reply, that is very useful info!But unfortunately I'm familiar with this info that w/o participate I can not select the clocking. That is normal behavior.My issue that I can not participate the VIC-BRI's on the NM-HDV slot and I c...

gabor.kovacs · 03-16-2007

Fred,First of all very appreciated for your reply on this topic!Well, the network clock participate is a different things here. It is not a solution unfortunately because there is two different clock source here. One from the WIC-BRI and the other on...

Member Since	‎03-14-2007 07:47 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	4
Total Helpful Votes Received	10

User Statistics

User Activity

what is "Another clk on Guido configured as primary"

Re: what is "Another clk on Guido configured as primary"

Re: what is "Another clk on Guido configured as primary"

Re: what is "Another clk on Guido configured as primary"