About klkunzler

klkunzler · 03-15-2007

I have attached a PDF of my basic setup as well as a copy of my config file (2611.txt) on my 2611. The VPN client connects, but no traffic passes through the tunnel. As the end result, I want to be able to have the VPN client get an IP address from...

klkunzler · 03-19-2007

I tried ip nat inside source route-map MAP interface ethernet0/0 with no results I also finished by adding the other configs). I'm still lost and not working.

klkunzler · 03-19-2007

My Cisco 2611 is not accepting the command. It won't allow anything after "ethernet0/0". it is expecting the end of the line after ethernet0/0.Any suggestions?

klkunzler · 03-17-2007

I'm not quite following the address scheme here. I am attemting the same 10000 ports to one nat command, I have 192.168.1.0/24 as my inside addresses and the internet via DHCP as outside address. eth0/0 is internet (DHCP) eth0/1 is private NAT (192.1...

klkunzler · 03-17-2007

Sorry for the Double post

klkunzler · 03-16-2007

The updated config is attached (2611-update.txt)

Member Since	‎03-15-2007 11:08 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	7

User Statistics

User Activity

VPN client connects, but no traffic passes through

Re: Static NAT to a range tcp ports

Re: Static NAT to a range tcp ports

Re: Static NAT to a range tcp ports

Re: Static NAT to a range tcp ports

Re: VPN client connects, but no traffic passes through