About MDSCiscoTech

MDSCiscoTech · 05-16-2017

I cannot make this work no matter what I do. This picture shows my intended goal. but I cannot ping between different devices. If I'm on VLAN 130 (192.168.130.77/24) with a pc plugged a port that is a member of VLAN130UP/VLAN132 .... I cannot ping a ...

MDSCiscoTech · 05-19-2016

Cisco RV130W port forwarding issue Port forwarding is not working, need to forward ports 1730 & port 7625 to phone system IP. Added single port forwarding in admin section and pointed to correct ip but will not successfully forward the ports. Canyous...

MDSCiscoTech · 04-18-2016

Have a scenario where 2 Cisco 3560 POE switches are linked together at different physical locations via fiber link. On each 3560 there is a default route that 0.0.0.0 0.0.0.0 FastEthernet0/1 On each 3560 a static ip is assigned to the above port whic...

MDSCiscoTech · 06-24-2015

What is the best scenario to tie together (2) sg300-28pp and 5 sg300-10pp?*Have set ip for each and upgraded all to latest firmware.*One switch will be directly connected to VPN/Firewall which is connected to ISP modem.*Need best suggestion for conne...

MDSCiscoTech · 04-19-2016

Theoretically as long as I do a wr mem on the 3560 to make sure the running config is copied to the startup before making any changes then I could do: ........................................ config t no ip route 10.2.0.0 255.255.0.0 FastEthernet0/1 ...

MDSCiscoTech · 04-19-2016

I had considered doing that but due to time constraints didn't have a chance, Yes the port FastEthernet0/1 on Switch A is still running that same config and the fiber is still connected there, is it possible to add ip route 10.2.0.0 255.255.0.0 172.1...

MDSCiscoTech · 04-19-2016

I only wish I could the business is basically 24/7 and my next available testing window will be early tomorrow morning like 4 a.m. I had to swap the fiber back into the 3560 (switch B) to resume normal operations after the SG300 didn't perform as exp...

MDSCiscoTech · 04-19-2016

In the scenario I'm attempting to replace switch B with the new SG300

MDSCiscoTech · 04-19-2016

In fact switch A(3560) main building has IP assigned to fastethernet 0/1 and switch B(3560) has IP assigned to FastEthernet0/7. But the port number should have no impact, the new SG300 has the IP address on gi48.

Member Since	‎06-24-2015 06:39 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	12

User Statistics

User Activity

Cisco SG300 VLANS Really need help.

Cisco RV130W port forwarding issue

Cisco 52 port SG-300 port routing

Multiple (7) Cisco SG300 switches connected?

Theoretically as long as I do

I had considered doing that

I only wish I could the

In the scenario I'm

In fact switch A(3560) main