Hi everyone,I have been working on a problem for a while but have yest to solve it. I have site A which need to access hosts on site B, this traffic need to go both ways.I have a site2site tunnel between site A and Site B that works fine the tunnel ...
HiSorry if this i a silly Q, but im normaly only dooing IOS config.I have little problem when trying to setup this unit.It boots ASA software 8.0.4 fine.When i go to enable mode and into configuration mode and try to configure ip on an interface i ha...
Hi,We have a case where we need to deny incoming traffic on the outside interface containing HTTP/1.0 requests. Im not sure if it has to be scripted or the inspection maps for HTTP can manage this.Help would be apprieciated.Jens
Hi GroupsI have a small problem. I have a 6506, 2 x 2500W, 1 x SUP2When bootet the "sh env" reportsfan-tray 1: fan-tray 1 type: WS-C6K-6SLOT-FAN fan-tray 1 version: 1 fan-tray 1 fan-fail: OKchassis per slot cooling capacity: 43 cfmambient temperat...
Hi all,I have two routers running OSPF, and wish to run my 1980's Netbios across OSPF to the LAN's in both ends. Is it possible at all, I know I have to forward UDP 137-139, but what about the broadcasts? Can they be "forwarded"?Thanks,Philip
Hi CSvensson87
Good to hear some results from others as well. We are not under attack and our egde routers are handling the problem right now as you also state.
We will await Cisco...
Thank you for your feedback.
Hi
We have testet it against a ASA5516 firewall with the linux command hping3 -1 -C 3 -K 3 -i u20.
We have the following config as stated in the suggestions.
icmp unreachable rate-limit 1 burst-size 1icmp deny any time-exceeded WANicmp deny any unrea...
Hello Sipos
Im also trying to enable anyconnect on a multiple context firewall, but I am unable to get as far as you.
I have made the shared folder and can see the anyconnect image in the admin context.
JASA1/admin/act/pri# sh webvpn anyconnect1. s...