Hi, We are currently running a multi-pod fabric (version 4.2.7), with N9K-C9336PQ spine switches. New spines will be the N9K-C9316D-GX I am trying to find a procedure for this swap and also for specific tips and tricks. Especially I would like to he...
Hi
I have a Cisco ACI lab setup and ran into this bug
https://bst.cloudapps.cisco.com/bugsearch/bug/CSCva54489
The bug suggests a downgrade or clean install. This setup is already running 1,5 year and I would like to know if there is not another work...
Hi,
We are running version 1.2(1m) and run into a error, when trying to add a port as a static binding to an EPG. Does anyone know if this is a known bug? Cannot find anything in the bug tool
apic1# conf apic1(config)# leaf 101apic1(config-leaf)# i...
Hello,
Could anyone please explain the main differences between AVS and DVS from a technical point-of-view. Or if you have a link to a URL or document that talks about these differences, that would be great!
many thanks
Michel van Kessel
Hello,
Could anyone please explain the main differences between AVS and DVS from a technical point-of-view. Or if you have a link to a URL or document that talks about these differences, that would be great!
many thanks
Michel van Kessel
Thank you for your information @Claudia de Luna and @Ezzedine , and sorry for this late response. But we had some delay with the hardware delivery
So the only big issue I see, is the fact that the current mpod uplinks to the IPN switches, are on p...
Hello Chris,
Thanks for your prompt reply. I have changed that option, and I can reach for example vCenter via inband to an EPG inside the Fabric. It's a strange issue, because I can reach all switches on the inband mgmt IP address from outside the...
Hello Chris,
I'm a bit stuck in the L3out situation. At the end, I am able to ping all the switches from via the L3out (which is located in the common:default in my case) but I cannot reach the APIC's.
I can reach the APIC's if I login to the Le...
Hello Chris,
I'm a bit stuck in the L3out situation. At the end, I am able to ping all the switches from via the L3out (which is located in the common:default in my case) but I cannot reach the APIC's.
I can reach the APIC's if I login to the Le...
