I have an urgent issue with the above switch: I have a connection on IP 192.168.1.21, Subnet 255.255.255.0 - this is on the default VLAN1 on the switch. I need to route this to IP 10.0.3.101, Subnet 255.255.252.0 - which is set up on VLAN2 on the switch. I have set the switch to Layer 3 via console. Could someone please advise how I setup this route? I am use the Browser based interface. Gavin ... View more

Hi Folks, Before I launch into this can I say that I am very much a novice with regards to Managed Switches and their configuration and I hope someone out there can assist me. I have the following equipment which I have connected to the switch: 1 x PLC Comms Card            IP:192.168.1.1     1 x HMI                                IP:192.168.1.3   1 x Bently Nevada Gateway   IP:192.168.1.10 All of the above are on subnet 255.255.255.0 All of the above communicate with each other during normal operation. Our client is connecting to the switch but his requirement is for his system to "see" the PLC Comms Card as follows: IP: 10.0.3.61 on Subnet 255.255.252.0 . Using the Internet Explorer interface connection I have created an additional VLAN (ID 2) on Port 10 with the intention of using this as the connection to the client ( I assume there will be further settings required to route the PLC connection to this port) but every time I try to assign the IP and Subnet values and click "APPLY" the changes are not made and the connection appears to hang leading me to reboot the switch. I have connected to the switch via console and changed the mode to Layer 3.  I also assume that it is OK for the three pieces of equipment to remain on the default VLAN.   Would it be possible for someone here to "walk" me through how I should setup this VLAN and ultimately achieve my goal. I would very much appreciate anyone's assistance on this. Very best regards Gavin Stewart             ... View more