About gavinstewart1971

gavinstewart1971 · 06-07-2012

I have an urgent issue with the above switch:I have a connection on IP 192.168.1.21, Subnet 255.255.255.0 - this is on the default VLAN1 on the switch. I need to route this to IP 10.0.3.101, Subnet 255.255.252.0 - which is set up on VLAN2 on the swit...

gavinstewart1971 · 04-23-2012

Hi Folks,Before I launch into this can I say that I am very much a novice with regards to Managed Switches and their configuration and I hope someone out there can assist me.I have the following equipment which I have connected to the switch:1 x PLC ...

gavinstewart1971 · 06-09-2012

Thanks Dave,I can now communicate from one VLAN to another. I have 2 x Hosts also on VLAN1 which do not have default gateway input capability - I can ping them but it usually times out after 1 response maybe 2. Is there a way I can setup a route in ...

gavinstewart1971 · 06-08-2012

Hi Dave,This is excellent and very helpful however one more question if you dont mind.I do not have the external router referred to in your response (nor the internet connection). I only want to make sure that bi-directional communication can be pos...

gavinstewart1971 · 06-08-2012

Thanks Dave,I have set it all up as you suggest but I cannot ping from VLAN1 to VLAN2 (I'm using 2 PCs to test this). Also, does this setup allow and external device (in this case a Honeywell Modbus Client) on VLAN2 to request information from VLAN1...

gavinstewart1971 · 04-23-2012

Hi again Randy,Thanks for your reply however I am a bit lost as to what I need to do. I assume that the whole config will be done via the console. Do I type in what you have given me above (less the text within brackets)? I havent used the console f...

gavinstewart1971 · 04-23-2012

Hi Randy,Thanks for your reply. The scenario you described is exactly what is happening although I dont seem to be able to get back on line to the switch with the IP address I assigned to VLAN2. I wasnt aware that by assigning an IP address and sub...

Member Since	‎04-23-2012 02:56 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	7
Total Helpful Votes Received	15

User Statistics

User Activity

Cisco SG300-10 - How to set up Inter VLAN routing.

SG300-10 VLAN Configuration

Re: Cisco SG300-10 - How to set up Inter VLAN routing.

Re: Cisco SG300-10 - How to set up Inter VLAN routing.

Re: Cisco SG300-10 - How to set up Inter VLAN routing.

SG300-10 VLAN Configuration

SG300-10 VLAN Configuration